EGO Power+ LB5300E Handbuch Seite 8

EN WARNING:
Always remove the battery pack from
the product when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing the
battery pack will prevent accidental starting that could
cause serious personal injury.
Before each use, inspect the entire product for damaged,
missing, or loose parts, such as screws, nuts, bolts,
caps,etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced.
APPLICATION
You may use this product for the purposes listed below:
◾
Clearing hard surfaces such as driveways and
walkways.
◾
Keeping decks and driveways free from leaves and
pine needles.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
ASSEMBLING/REMOVING THE BLOWER TUBE
◾
To Assemble (Fig. B)
Align the groove and push the tube onto the blower
housing until you hear a "click".
◾
To Remove (Fig. C)
Press the tube-release button and pull the tube out.
INSTALLING/REMOVING THE BATTERY PACK (Fig. D)
Use only with battery packs and chargers listed
in fig.A
Charge before first use.
◾
To install
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click".
◾
To remove
Depress the battery-release button and pull the battery
pack out.
WARNING:
Always take care to note the location of
your feet, children, or pets when pressing the battery-
release button. Serious injury could result if the battery pack
falls. NEVER remove the battery pack when in a high location.
STARTING/STOPPING THE BLOWER (Fig. E)
◾
To Start
Depress the trigger and hold it. After a short delay, the
blower will begin to run.
8
56 VOLT LITHIUM-ION CORDLESS BLOWER — LB5300E
To Stop
Release the trigger.
ADJUSTING THE AIR VELOCITY
◾
To Increase/Reduce the Air Velocity
Turn the air velocity adjusting knob clockwise/
counterclockwise.
◾
To Enhance the Air Velocity
Press the boost button to achieve the maximum air speed.
NOTICE:
Once the boost button is released, the blower
will resume the previous speed.
OPERATING THE BLOWER
◾
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
◾
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
◾
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when
water is available.
◾
Conserve water by using power blowers instead
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
◾
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
◾
After using blowers or other equipment, clean up!
Dispose of debris properly.
MAINTENANCE
WARNING:
When servicing, use only identical
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician.
WARNING:
To avoid serious personal injury, always
remove the battery pack from the product when cleaning
or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.