Maintenance Instruction - Herth+Buss 95980806 Handbuch

Operating Instruction
7.4 Powering a USB Device
The booster is a power source for all acces-
sories that are equipped with a USB plug. The
USB port provides up to 2.1A at 5V DC.
1. Ensure the battery clamps are securely
clipped on the storage holders.
2. Press the USB button on the front of
the unit.
3. Plug the device into the USB port on the
front of the unit.
4. Turn the USB device on.
5. Reverse these steps when finished using
the USB port.
NOTE
The USB port will shut-off automati-
cally after 60 minutes, if no device is
connected. Extended operation of a
USB device may result in excessive
battery drain. Recharge the booster im-
mediately after unplugging the device.
8. Fuse replacement for the booster
The booster is equipped with an inline fuse,
to protect the battery from overload.
Fuse Specification:
Booster 12V:
Fast blow, DC automotive type, rated 32V,
300A (Bussman/Audio Ohm Srl)
Booster 12/24V:
Fast blow, DC automotive type, rated 32V,
500A (Bussman/Audio Ohm Srl)
25
95980806 | 95980807
WARNING
Keep away from sparks and flame –
battery could emit explosive gases.
1. Allow the fuse to cool
down completely (ap-
proximately 5 minutes).
2. Make sure the switch
is in the OFF position
and the unit is unplugged from the
external charger.
3. Remove the positive (RED) clamp from the
side of the unit and locate the fuse holder.
4. Open the fuse holder by removing
its cover.
5. Using a wrench, remove the first nut and
bolt securing the fuse on the positive
cable. Repeat the same steps for the
second nut and bolt. Remove the open
fuse and replace it with a new one of the
same type and rating.
6. Tighten the nuts and bolts to secure the
fuse, and then replace the cover of the
fuse holder.
7. The unit is now ready to use.

9. Maintenance instruction

9.1. Cleaning and user maintenance should
not be done by children without supervision.
9.2. Unplug the charger from the booster
before attempting any maintenance or
cleaning.
9.3. Use a dry cloth to wipe all battery cor-
rosion and other dirt or oil from the battery
clamps, cords and the booster case. Do not
use cleaning fluids.
EN