Herth+Buss 95980806 Handbuch Seite 24

Operating Instruction
1. Complete charging may take up to 24
hours.
EN
NOTE: The yellow CHARGING LED on the
charge will remain flashing after display
shows 100%, because charger enters
automatically into maintaining mode.
2. After charge is complete and the boos-
ter is ready for use, disconnect the
charger from the AC outlet, and then
disconnect the charger from booster.
7. Operating instructions
7.1. Jump starting a vehicle engine
WARNING
A spark near the battery may
cause a battery explosion. To
reduce the risk of a spark
near the battery.
1. Turn the vehicle's ignition OFF before
making cable connections.
2. Connect the booster to the vehicle's
battery as described in section 4.
If you have connected the clamps back-
ward, an audio alarm will sound. DO
NOT turn the booster ON/OFF switch to
the ON position. This could cause serious
damage to the booster or the vehicle.
Reverse the connections and the audio
alarm will stop.
3. Turn the booster ON/OFF switch to the
ON position.
4. Crank the engine. If the engine does not
start within 8 seconds, stop cranking and
wait at least 3 minutes before attempting
www.herthundbuss.com
95980806 | 95980807
to start the vehicle again. This permits
the booster battery to cool down.
5. After the engine starts, immediately turn the
booster ON/OFF switch to the OFF position.
6. Disconnect the booster from the vehicle,
as described in section 4.6.
7. Return the battery clamps to the clamp
holders. Recharge the booster as soon
as possible after use.
7.2. When using the other features of the
booster, always observe the following steps:
1. Ensure the battery clamps are securely
clipped on the clamp holders.
2. Charge the booster as soon as possible
after using the feature.
7.3. Powering a 12V DC device:
The booster is a power source for all 12V
DC accessories that are equipped with a 12V
accessory plug. Make sure the device to be
powered is OFF before inserting the 12V DC
accessory plug into the 12V DC accessory
outlet.
1. Open the protective cover of the DC po-
wer outlet on the front of the booster.
2. Plug the device into the outlet and turn
the device on (if required).
3. If the device draws more than 15A or has
a short circuit, the circuit breaker of the
booster will trip and disconnect the po-
wer to the device. Disconnect the device
and the beaker will automatically reset.
The DC power outlet is wired directly to
the internal battery. Extended operation
of a 12V device may result in excessive
battery drain. Recharge immediately
after unplugging the device.
24