Herth+Buss 95980806 Handbuch Seite 23

Operating Instruction
6.1.3 Charging the internal battery using
the included wall charger.
IMPORTANT
Only use the charger that was in-
cluded with the booster to charge
the internal battery of the booster.
Using any other charger or using the
included charger for any other pur-
pose could result in personal injury
or property damage.
WARNING
6.1.4 This battery charger is for use on a nomi-
nal 230V 50 Hz circuit. The plug must be
plugged into an outlet that is properly installed
in accordance with all local codes and ordi-
nances. The plug pins must fit the receptacle
(outlet).
DANGER
Never alter the AC cord or plug provi-
ded – if it does not fit the outlet, have
a proper outlet installed by a qualified
electrician. An improper connection
can result in a risk
of an electric shock or electrocution.
23
Risk of electric
shock or fire
95980806 | 95980807
6.1.6 An extension cord should not be used
unless absolutely necessary. Use of an im-
proper extension cord could result in a risk
of fire and electric shock. If an extension
cord must be used, make sure:
That the pins on the plug of the extension
cord are the same number, size and sha-
pe as those of the plug on the charger.
That the extension cord is properly wired
and in good electrical condition.
That the wire size is large enough for the
AC ampere rating of the charger.
Recommended minimum cross-section
size for extension cord:
30.5 meters long or less – use a 1.0 mm²
extension cord.
Over 30.5 meters long – use a 1.25 mm²
extension cord.
6.1.7 Charging
Make sure that both the charger and booster
are placed on a dry, nonflammable surface.
To charge the booster, connect the charger
included into the charging port that is loca-
ted at the front of booster.
Confirm the AC outlet voltage matches the
input voltage of the charger.
1. Connect the charger into the electrical
wall outlet and confirm that the Green
POWER LED on the charger turns on.
2. Check that the yellow CHARGING LED in
charger starts flashing slowly to indicate
that charge process has started. To know
status of the charge, check the percenta-
ge shown at the display in booster.
3. When the display in booster shows 100
(%), the internal battery is fully char-
ged and the booster is ready to use
EN