Westinghouse WKSO706 Bedienungsanweisungen Seite 8

7. Ensure the blender is unplugged from the
wall socket. Place the jug on the power base,
observing the position of the electric socket
under the jug. Do not twist the jug.
8. Plug the blender to the wall socket. The blender
will turn ON with a beep sound and enter Standby
Mode. The display will blink "----" and the START/
STOP button will light up.
9. Press the START/STOP button, the display
will show "00:00" (mm:ss). Then select a
Preset Program (see HOT OR COLD PRESET
PROGRAMS).
10. Press the START/STOP button again to confirm.
The blending will start immediately. The display
will countdown showing the remaining time of the
program.
- To add ingredients during the blending
process, remove the feed cap and add the
ingredients into the jug. Use the stirring rod if
required.
- DO NOT remove the lid during blending, as
the built-in lid safety feature will automatically
stop the program.
NOTE: To stop or cancel an ongoing program at any time, press the START/STOP
button. Select a preset program to start again.
WARNING: DO NOT insert your hand or any sharp or pointed object into the
jug during blending, as this may result in serious personal injury or damage the
appliance.
11. Once the Preset Program is complete, the blender
will beep and stop. The display will show "00:00"
to indicate end of the program.
EN
8
WKSO706_Power Blender_5L_IB.indd 8 19/11/2019 12:24:11