Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation instruction sandblaster ST-555
product codes: 200 555 ...
Description
The sandblasting system or set, together with a
high-pressure washer, produces a high-pressure jet
consisting of a mix of water and sand. The high-
pressure washer can also very easily be converted
to a wet sandblaster. The sandblast injector ST-555
is offered as a whole unit, comprising the jet nozzle
with injector, HP lance, double suction tube and
connection hose.
During use, it is worth noting that due to the mutual influence of the operational parameters,
the maximum values should be set accordingly lower. Working permanently at maximum
load can reduce the service life of the sandblaster. The sandblast injector is designed for a
permanent use up to approx. 200 bar. For optimum cleaning results, the blasting agent should
be set to an optimum grain size. A grain size of 0.4 – 1.2 mm is generally recommended.
General safety notes / Warning
•
This Suttner product is state of the art and complies with generally recognised health and
safety regulations. Due to the high pressures and temperatures nonetheless there is the
danger of material damage and injury for users and other persons. Please comply with
these Operating Instructions at all times and the relevant regulations for jet work.
For details regarding personal protective equipment, refer to the German accident pre-
vention regulations „Personal protective equipment" (BGV D26 §11). Personal protective
equipment includes respiratory equipment for jet work, impact protection clothing which
covers the shoulders and body, safety gloves and safety boots.
Do not use the equipment if persons without protective clothing are within range.
•
Before starting work, check the high-pressure system (spray equipment, hoses,
screw connectors, etc.) for signs of leakage and damage.
•
Cease operation immediately if any leakage or malfunctions occur.
•
The spray gun trigger lever must not be jammed in the open position or prevented from
closing in any other manner.
•
Do not aim the spray nozzle at yourself or other living creatures, not even to clean
clothing or footwear.
•
Never place your hands in the way of the exiting high-pressure jet.
•
Do not touch anything which is not insulated if you are working with consumables and
additives where the temperature exceeds 45° C.
•
Due to the high pressure of the exiting jet, you will experience a recoil force.
•
Please ensure that you stand firmly and hold the spray gun and sandblaster tight using
both hands.
•
Do not use the spray equipment when on slippery floors or ladders.
•
Secure yourself on scaffolding or staging against falling.
•
During sandblasting, particles of dirt, grains of blasting agent and other loose
particles are displaced from the surface being cleaned. Due to the energy
of the high-pressure jet, these particles are vastly accelerated and may lead to material
damage and personal injury.
•
Do not spray any objects containing harmful substances (e.g. asbestos) or which
conduct electricity. The sandblaster must not be used to clean fragile surfaces.
Page 1, ver. 6.2017
Attention!
Please read these Opera-
ting Instructions carefully
before using the equipment!
Keep the Operating
Instructions in a safe place
for future use or for the
next user! These Operating
Instructions were prepared
with great care. There is no
responsibility for any possi-
ble errors in the Operating
Instructions or for any con-
sequences arising thereof!
As determined during test-
ing, the sandblast injector
ST-555 is designed for a
maximum pressure range
up to 500 bar and a tem-
perature up to 100° C. The
user must wear respiratory
equipment for jet work,
impact protection clothing
which covers the shoulders
and body, safety gloves
and safety boots. The local
safety regulations currently
in force should always be
observed.
500 bar
100 °C
www.rm-suttner.com
Werbung
Inhaltsverzeichnis
Fehlerbehebung
