Cameo LED COLOUR BAR Bedienungsanleitung Seite 9

MODE SELECTION / DMX CONTROL MODE:
AUTO RUN MODE
In Auto Mode the chasers are called up automatically in a continuous loop. Press the MODE button to select the
AUTO mode. Press the ENTER button to select the desired frequency of the loops. The desired frequency of the loops
(Frequency = FQN 01-99) can be selected by using the UP or DOWN buttons. Please press the ENTER button to
confirm.
SLAVE MODE
Press the MODE button to enter SLAVE MODE. Link the slave unit and the master unit by using a DMX cable. The
slave unit will follow in sequence with the master unit.
SOUND CONTROL MODE
Press the mode button to select Sound Control Mode. The unit will follow the beat of the music thanks to the built
in microphone. Press ENTER again to adjust microphone sensitivity (Sensit: 00-31) by using UP and DOWN buttons.
The desired frequency of the loops (Frequency = FQN 01 - 99) can be set by using the UP and DOWN buttons.
DMX ADDRESS SETTING MODE
Press the MODE button until the display shows DMX512 MODE. Press the ENTER button and the display shows: 001.
Set the desired address by using the UP or DOWN buttons. Please press the ENTER button again to confirm.
To select one of three different DMX channel modes (2 CH, 3 CH, 4 CH, 6 CH, 19 CH) press ENTER and set the desi-
red mode by using the UP and DOWN buttons. Press the ENTER button again to confirm. Please see the following
DMX protocol graphics for the respective channel values.
9