Driver Installation In Macos - i-tec Thunderbolt 3 Gebrauchsanweisung

Quick Start
For Windows 7/8/8.1, download the drivers from our website www.i-tec.cz/en on the
"Manuals, drivers" tab of this product or on www.i-tec.cz/setup. Run the installation
from the downloaded file, select the installation language, and follow the instructions
on the screen.
In Windows 10, the docking station can be connected directly, drivers are automatically
installed from the system when connected to the Internet.
Note: In Windows 7 / 8 / 8.1 / 10, install the drivers as the "Administrator" user. The
screen may blink while the drivers are being installed, this is a standard process. Once
the installation is complete, we recommend restarting the notebook / tablet.
DRIVER INSTALLATION IN MACOS X
ATTENTION! Do not connect the dock to your Mac until you install the appropriate
drivers. Drivers must only be installed before first use. We recommend that you have the
latest macOS operating system installed.
Download drivers from our website www.i-tec.cz/en/ on the "Manuals, drivers" tab of
this product and run the installation.
CONNECT THE HDMI / DISPLAY PORT MONITOR
Use an HDMI / DP cable to connect the monitor to the docking station. During the
installation of an additional monitor, the laptop / tablet monitor may may blink, this is a
normal state. Docking station supports up to two monitors. Graphic Interface: 2x HDMI
and 2x Display Port. Resolution:
1 monitor connected via 2 DP cables (1x DP + 1x DP ports), resolution up to 5K
5120x2880@60Hz, the graphics card on your computer must support 5K resolution
2 monitors connected simultaneously (1x DP + 1x DP or 1x DP + 1x HDMI or 1x HDMI + 1x
HDMI ports), resolution up to 4K 4096x2160@60Hz
| 7
ENGLISH ENGLISH