Citizen Systems CT-S251 Benutzerhandbuch Seite 29

Auto reconnection
With iOS device Bluetooth communication, a connection between a paired iOS device
and the printer is not automatically restored after it is lost. However, when auto recon-
nection is enabled, the printer tries to reconnect with an iOS device after two-way com-
munication is enabled and automatically restores the connection.
CAUTION
This function is enabled when shipped from the factory. (MSW13-6)
Auto reconnection can take some time to connect when the host is not an iOS device.
 Even if the partner device is an iOS device, the conditions below can interfere with the auto
reconnection function.
Ÿ When you want Bluetooth communication to cut off after printing is complete
Ÿ When there are multiple iOS devices printing on the same printer
Under such conditions, disable auto reconnection.
Enabling and disabling auto reconnect
During self test, open the cover, press the FEED button 3 times and close the cover
-> Auto reconnect = Valid
During self test, open the cover, press the FEED button 4 times and close the cover
-> Auto reconnect = Invalid
At the end of self test, new setting will be printed as Auto reconnect [Valid] or [Invalid].
29
— —
Refer to 4.3 Self Test