INSTRUCTION MANUAL
Insert the strap in the centre of the hip belt twice through the
spacer starting from the top. Fasten the end of the strap with
a Velcro fastener.
Fig.5
Install the lever (Fig. 6/item 1) by tapping the
lever on the connector (Fig. 6/item 2), until
3
the holes on the lever and on the flat bar are
aligned. Slide the pin in from above (Fig. 6/
item 3).
1
PL
EN
2
Fig.6
DE
CAUTION: The lever is not ready for use immediately after removing the device from the
RU
packaging.
Check that the piston valve body (Fig. 7/item 2) is equipped with an O-ring (Fig. 7/item 3) and connect it with
the lance (Fig. 7/item 1) by screwing in to obtain a tight connection.
3
2
1
Fig.7
16