Fastening The Heater - Kirami Original Tiny S Gebrauchsanweisungen

© Kirami Oy, Finland
In case the tub is placed near buildings, e.g. the edge of a terrace, ensure that the chimney top is
located away from flammable
materials. Remember to check the
distance both sideways and vertically
in order to avoid the risk of fire. Local
rules may vary.
There should be no flammable material
located in front of and below the
furnace. In practical terms, this means
that an area of incombustible material,
such as concrete, sand, or a metal
plate, is needed in front of the furnace.
The stove will not heat up above the
water temperature as the stove is
surrounded by a water jacket. The chimney and door of the stove will heat up, however.

Fastening the heater

Heater for plastic tubs is connected with rubber hoses to the Ø75mm
PVC pipes on the tub. Tiny tubs will need a support under the Micu™
heater that is supplied with the package. It is good to use the support
during the installation. If there are two sets of rubber hoses supplied
then use the longer ones with Tiny hot tub.
1. Attach the upper rubber tube to the stove and tighten the
stove-side hose clamp securely.
2. Attach the lower rubber tube to the stove, but do not tighten it
yet and leave the rubber tube closer to the edge.
3. Push the lower tube onto the tub first.
4. Then attach the upper tube.
5. When you are done, tighten all hose clamps securely.
It is advisable to spray silicon spray or other lubricant like soap
inside the rubber hoses to tighten the hose clamps evenly and
to prevent the hoses from wrinkling.
INSTRUCTIONS FOR USE: Original Tiny ™ hot tubs
28/84
26.03.2020
4 / 11