Automatically Temperature Corrected (Atc); Set-Up Automatically Switch-Off Time - TFA HUMIDCheck PRO Bedienungsanleitung

3. Automatically Temperature Corrected (ATC)

Switch the instrument on and select the appropriate wood calibration scale as
detailed in sections 1. Using a hammer and nail of nominal 3 mm diameter, make a
hole in the wood to be tested. Remove the nail and push the Temperature Probe into
the hole until the tip is at the required depth. Connect the Temperature Probe into the
instrument via the "
can obtain the automatically temperature corrected (ATC) moisture value. If you need
to reading current temperature of timber press "
temperature. Press "
Pressing " " button the LCD display moisture value again. (Temperature Range: -
°C ~ 80°C
35 ).
4. Set-up Automatically
Combinatorial using "
automatically switch-off time. Depress the "
" " button will change automatically switch-off time (disable automatically switch-
off or set from 1 to 9 minutes) by change the code as detailed in the following table.
Code Description
0 Disables automatic switch-off
1 Selects automatic switch-off at 1 minute
2 Selects automatic switch-off at 2 minutes
3 Selects automatic switch-off at 3 minutes
...... ......And so on to......
9 Selects automatic switch-off at 9 minutes
Temp
" socket. Then using this instrument to measure timber
T
" button the LCD will display the other °C or °F temperature.
" + "
T
" button, then LCD will display the
Switch-off Time
" button can change the default
" button don't release and press the
- 15 -