When The Work Is Done - Bosch bx1 Gebrauchsanweisung

en de
7
Figure
Press the on/off button in the direction of the
arrow to switch your vacuum cleaner on/off.
8
Figure
Adjust the suction by turning the on/off
button in the direction of the arrow.
Set the power setting to maximum for the
best results when vacuuming.
Vacuuming
9
Figure
Adjust the adjustable floor tool:
Rugs and carpets
Hard floors/parquet
10*
Figure Vacuuming with accessories
Attach the nozzles to the tube or handle as
required:
a) Crevice nozzle for vacuuming crevices and
corners, etc.
b) Upholstery nozzle for vacuuming upholstered
furniture, curtains, etc.
c) Hard furnishing brush
For cleaning window frames, cabinets,
mouldings, etc.
d) Hard-floor brush*
For vacuuming hard floors (parquet flooring,
laminate flooring, wooden floorboards, stone
floors, etc.)
11*
Figure
Pet hair upholstery nozzle
For easy and thorough removal of pet hair
(attach to handle or suction pipe as required).
To clean the pet hair upholstery nozzle,
simply vacuum using the handle.
If it is very dirty, the pet hair upholstery nozzle
can also be opened.
To do this, turn the two screws on the sides
of the nozzle (e.g. using a coin) and remove
the inner part from the nozzle.
After cleaning, replace the inner part (make
sure it is correctly seated) and screw to the
housing.
* Depending on equipment
12
Figure
Figure
=>
!
=>
Figure

When the work is done

Figure
Figure
12
You can use the parking aid on the back of
the vacuum cleaner if you wish to stop
vacuuming for a short time.
Once you have switched off the vacuum
cleaner, slide the catch on the floor tool into
the groove at the rear of the appliance.
13
To store or transport the vacuum cleaner, use
the storage aid on the underside of the
vacuum cleaner.
Stand the vacuum cleaner up on its end.
Slide the catch on the floor tool into the
groove on the underside of the appliance.
CAUTION: Do not operate in an
upright/vertical position.
14
The appliance can also be carried using the
carrying handle when vacuuming steps, for
example.
15
Unplug the vacuum cleaner.
Tug the power cord briefly and let go. The
cable then rewinds automatically.
16*
Unlock the telescopic tube by moving the
sliding button in the direction of the arrow
and slide one tube into the other.