Operation; Transport Position; Service And Maintenance - Ferm MSM1039 Bersetzung Der Originalbetriebsanleitung

Note: Always replace both carbon brushes at the
same time, never use a mixture of old and new
brushes.
Mounting the dust bag
Fig. 1
Press in the clamp of the dust bag (13) and slide
it onto the opening on the back of the machine.
The dust bag stays in place when you release the
clamp.

4. OPERATION

Using the mitre saw
Fig. 1
Before use, always check for faults or
defects!
• Set the desired sawing angle of the machine.
• Put the plug into the socket.
• Fix the piece of work in place using the clamp
(7): make sure that the material is well clamped
in place!
• Hold the material tightly on the left side while
making sure that you keep a safe distance
from the blade of the saw.
• To start the machine, press and hold the Lock­
off button (3) and press the on/off switch (1).
• Make sure that the saw blade has reached full
speed before allowing it to touch the piece of
work to be sawn.
• Now bring the saw slowly downwards so that
the saw blade saws through the piece of work
and passes through the slot in the table. Do
not put any pressure on the saw. Give the
machine time to saw through the piece of work.
• Bring the machine gently up again and switch
it off by letting go of the switch (1).
Using the slide-function
Fig. 1
The machine must be firmly bolted to a
workbench.
Use the slide­function for sawing wide
workpieces:
• Fix the piece of work in place using the clamp
• Loosen the knob (12)
• Slide the machine completely towards yourself
• Turn on the machine using the switch
• Bring the saw slowly downwards so the saw
blade saws through the piece of work
• Push the machine slowly backwards
• Bring the machine gently up again and switch
it off by letting go of the switch
Using the laser
Fig. 2
• To switch on the laser, press the on/off switch 2.
• To switch off the laser, release the on/off
switch 2.

Transport position

When moving the saw, make sure the saw is
in inward position. Check that all locks and
tensioning devices are secure:
• Make sure the mitre angle is set to 0°
• Make sure the bevel angle is set to 0°
• Lock the Knob adjusting saw angle (9) by
turning it clockwise
• Slide the machine completely towards yourself
• Lock the sliding function by turning Kob over
sliding support (12) clockwise
• Unlock the Lock pin (5) on the right hand side
of the machine
• Push the machine completely downwards
• Lock the Lock pin (5) on the right hand side of
the machine
Only lift the machine by the solid underside of the
machine. Do not lift the saw by the switch handle.

5. SERVICE AND MAINTENANCE

Always make sure that the machine is
not connected to the mains electricity
when you carry out any maintenance of
the mechanism.
Slide rails
Dirt can damage the slide rails and thereupon the
operating of the machine.
• Clean the slide rails regularly with a soft cloth.
• Drip some lubricating oil on the slide rails
• Move the mitre saw forwards and backwards
so the oil spreads over the complete rails
These machines are designed to function for a
long time without any problems with a minimum
9