Specifications - Makita DHP456RMJ Betriebsanleitung

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Star marking
5. Indicator lamps
6. Check button
7. Switch trigger
8. Lamp
9. Reversing switch lever
10. Speed change lever

SPECIFICATIONS

Model
Concrete
Steel
Capacities Wood
Wood screw
Machine screw
High (2)
No load speed
-1
(min )
Low (1)
High (2)
Blows per
minute
Low (1)
Overall length
Net weight
Standard battery cartridge
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS HAMMER DRIVER
DRILL SAFETY WARNINGS
1. Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
Explanation of general view
11. Action mode changing ring
12. Adjusting ring
13. Graduation
14. Arrow
15. Sleeve
16. Groove
17. Hook
18. Screw
19. Bit holder
20. Bit
DHP446
6 mm x 75 mm
1.4 kg 1.7 kg
BL1430/
BL1415N
BL1440
D.C. 14.4 V
ENE039-1
GEA010-1
GEB056-5
21. Blow-out bulb
22. Limit mark
23. Rear cover
24. Recessed part
25. Spring
26. Arm
27. Carbon brush cap
28. Hole
13 mm
13 mm
38 mm
10 mm x 89 mm
M6
0 - 1,500
0 - 400
0 - 22,500
0 - 6,000
206 mm
1.6 kg
BL1815/BL1815N/
BL1820/BL1820B
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
4. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
5. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Do not leave the tool running. Operate the tool
only when hand-held.
DHP456
1.8 kg
BL1830/BL1840/BL1840B/
BL1850/BL1850B
D.C. 18 V
5