Setting The Time - Patek Philippe CH 28-520 HU Handbuch

INSTRUCTIONS
WINDING CROWN
The winding crown is used to manually wind the
watch (position 1) and to set the time (position 2).
WINDING
Your watch incorporates a self-winding movement.
The movements of your wrist set a centrifugal mass
in motion; this tensions the mainspring, which stores
the energy. When you take off your fully wound
watch, it will continue to run for at least 50 hours.
When it has stopped after depleting the power
reserve, it can be rewound by hand (about 10 clock-
wise turns of the crown).
8

SETTING THE TIME

To set the time, proceed as follows:
1. Press the time-zone selection pusher at 10 o'clock
repeatedly until the city name that corresponds to
your time zone is at 12 o'clock.
2. Pull the crown out slightly and move the hands
in either direction until they indicate the time in
your time zone. Make sure the 24-hour disk
cates the correct time of day directly opposite the
city name at 12 o'clock.
Once you have set the correct time, push the crown
home again.
Note: After this setting, the time and the city on the
24-hour disk indicated by the arrow at 12 o'clock corre-
spond to the time displayed by the hands.
9
indi-