Symbol Description - HANSGROHE Decor 31171223 Gebrauchsanleitung, Montageanleitung

Symbol description
Do not use silicone containing acetic acid!
Safety Function (see page 9)
The desired maximum temperature for example max. 38ºC can be pre-set thanks
to the safety function.
Maintenance (see page 10)
• The check valves must be checked regularly according to EN 806-5 in
accordance with national or regional regulations (at least once a year).
Dimensions (see page 8)
Flow diagram (see page 8)
free flow

with EcoSmart
®

without EcoSmart ®
Spare parts (see page 12)
000 = Chrome Plated
Protected area (see page 6)
0, 1, 2
Cleaning (see page 11)
Never use high pressure cleaners or steam cleaners to clean the fittings.
Cleaning washbasin (see page 11)
Operation (see page 9)
Hansgrohe recommends not to use as drinking water the first half litre flowing from
the tap in the morning, after the hygiene rinse is enabled, or after prolonged
non-use. With activated hygiene flushing, the fitting opens for 10 s every 24 h after
the last operation.
Hygiene rinse
To enable or disable the hygiene rinse, proceed as follows:
• Disconnect electrical plug connection between fitting and battery housing or
power pack. During this time, briefly reach with your hand into the detection
area of the sensor window so that the capacitor discharges. Restore the power
connection after 10 s.
• The LED blinks to indicate the software version (e.g. blinking once = software
version 1)
• wait for LED to go out
• Cover the sensor window completely with your hand or a white piece of paper
for 5 s - 10 s. (Water output starts for 5 s)
• Uncover the sensor window
• the currently enabled mode is indicated by the flashing of the LED: 1 x =
enabled, 2 x = disabled
• A subsequent change of operating mode is possible again after calibration
• The fitting only returns to normal operation 60 s after the last change of
operating mode
Permanent rinse
After setting the parameters for the hygiene rinse or making a net reset, wait for
approx. 90 s before you can enable the „Permanent rinse" function.
• cover sensor window completely with your hand or a white piece of paper
• The fitting opens for approx. 5 s and immediately closes again. If the fitting
opens again after approx. 5 s, the viewing window must be uncovered.
• Permanent rinse is enabled for approx. 180 s and can be interrupted at any
time by a movement in the field of vision.
English
Thermal disinfection
• Thermal disinfection pursuant to process sheet DVGW W 551 (≥ 70°C /
> 3 min) must only be carried out by qualified personnel.
• Risk of scalding with thermal disinfection!
• The cold water feed must be locked during thermal disinfection. Afterwards,
„Permanent rinse" can be enabled.
Net reset
A net reset causes the fittings to re-adjust
• Interrupt the voltage supply to the fittings
• Briefly reach into the field of vision of the fittings to cause the capacitor to
discharge
• Wait for approx. 10 s, then plug the connectors in again
• The fittings will re-adjust during the next 30 s. Do not reach into the field of
vision during this period of time.
Assembly (see page 6)
3