Antenna Settings For Digital Satellite Channels And Searching For Channels Automatically With Scr System; Antenna Settings For Digital Satellite - Grundig 50 GUB 7040 Benutzerhandbuch

DETAILED CHANNEL SETTINGS
Antenna settings for digital
satellite channels and searching
for channels automatically with
SCR system
Notes:
Your TV supports SCR system (Single
7
Channel Router). SCR (Single Channel
Router - EN 50494).
LNB settings described in the following
7
section require significant expertise on
satellite systems. Contact your authorised
dealer about this matter.
1 Press » «.
>
2 Press » « to select »Settings«.
>
3
Press » « then »
V
confirm with » «.
– »LIVE TV« menu will be displayed.
4 Confirm »Channel Scan« with »
– »Please make sure your antenna is setup
and plugged into your device« will be
displayed.
5
Confirm »Next« with »
6 Press » « or »
V Λ
press » « to confirm.
7
Press » « or »
V Λ
press » « to confirm.
8 To delete the previously saved channels and
search, select »Yes«;
or
to continue searching without deleting the
channels, select »No, keep existing« and
press » « to confirm.
9 Press » « or »
V Λ
» « to confirm.
10
Press » « or »
V Λ
want to search from the list and press »
to confirm.
– »Satellite Connection« will be displayed.
« to select »Live TV« and
«.
«.
« to select the country and
« to select »Satellite« and
« to select »Full« and press
« to select the satellite you
----------------------------------------------------
11 Press » « to select »Single Cable« and
V
press » « to set it to »ON«.
12
Press » « to select »User Band« and press
V
» « or »
§ $
that is being used.
13 Press » « to select »Band Frequency« and
V
confirm with »
14
For band frequency, press »
or » « to select the required numbers and
Λ
press » « to move to the next character.
Enter the frequency and press »
select »Next«.
Notes:
Use installation equipment supported /
7
suggested by your SCR Switch.
Other users / receivers connected to the
7
system may be affected if the specified user
band number and frequency are changed
during installation.
User band and User band frequency are
7
specified on the SCR switch used; and each
user / receiver must select a specified user
band and user band frequency.
With SCR satellite system, auto search by
7
several users / receivers at the same time
may cause problems.
15
Press » « to select »Scan Mode« and use
V
» « or »
§ $
For free digital TV channels only, select
(Free); for paid digital TV channels, select
(Scrambled); for both, select (All).
16
Press »
8!
– »Search« menu will appear and channel
search will start.
– Channel search will take some time
depending on the number of the channels
to be searched.
17 Confirm »Done« with »
«
setting process and display the Home menu.
« to select the antenna socket
«.
< >
«, »
8!
« to select the scan mode.
« to start searching.
« to complete the
ENGLISH
«, » «
V
« to
81