Connecting External Data Medium; Removing The External Data Medium - Grundig 50 GUB 7040 Benutzerhandbuch

USB PROCESS
Connecting external data
medium
It is advised to switch the television to stand-
by mode before connecting the External Data
medium. Connect the device and then switch the
television on again.
Before disconnecting the data medium, first of
all, the television must be switched to standby,
otherwise files may get damaged.
Notes:
USB1 port of the TV supports 500 mA
7
current according to the USB standard.
Devices such as external hard disk and
etc. that consume more power can only be
connected to the USB(HDD) interface of
the television.
If you are using a power cable for the
7
external hard disk that you have connected
to the USB(HDD) USB interface, then the
power cable of the external hard disk must
also be unplugged when the TV is turned
off.
You must not disconnect the USB Device
7
from the TV while a file on the USB Device
is being read by the TV.
A bi-directional data transfer as defined for
7
ITE (Information Technology Equipment)
devices in EN 55022/EN 55024 is not
possible.
USB transfer is not an operating mode in
7
itself. It is only an additional function.
-----------------------------------------------------------------------------------------------------
USB(HDD)
1 Connect the USB(HDD) interface of the
television and the corresponding socket on
the data device (external hard drive, digital
camera, card reader or MP3 player) using
a USB cable;
or
plug the memory stick in one of the »USB1«
sockets of the television.
Removing the external data
medium
Disconnect data media before removing it.
1
Press » «.
>
2 Press » « to select »Settings«.
3
Press » « and then »
V
Software«, and confirm with »
4
Press » « or »
V Λ
and confirm with »
5 Confirm »Eject USB Drive« with »
– »USB Storage Ejected« will be displayed.
6
Remove the data medium from the socket.
>
« to select »Device &
«.
« to select »USB Drive«
«.
«.
ENGLISH
33