Specifications; Installation - Kicker KMFC Benutzerhandbuch

SPECIFICATIONS

Model:
Rated Impedance [Ω]
Sensitivity [1W, 1m]
Peak Power Handling [ Watts]
Continuous Power Handling [Watts RMS]
Enclosure Diameter/Width [in, cm]
Enclosure Depth [in, cm]

INSTALLATION

Step 1: Determine the location, placement, and mounting confi guration of the KMFC cans onto the
surface to which you are mounting. The KMFC may be mounted to a fl at surface at an angle of 0, ±5°,
or ±10°. Spreading the KMFC Loaded Marine Cans apart will provide better stereo performance, and is
usually preferable. When determining the best locations for mounting, be careful to look for obstacles or
obstructions that could complicate mounting the KMFC. Please keep in mind the routing of your speaker
wires as this can affect where you fi nally mount your cans. You will need to mark and drill three holes in
the mounting surface at 5/16" (8mm) in diameter; two for the mounting bolts, and one for wire routing.
Use the included mounting hardware as a template. The placement of the holes must line up with the fi nal
position of the mounting hardware; ie the holes should be about 90° from the direction the speakers will
be aimed and in-line with the wiring coming from the mounting bracket.
Step 2: Loosely thread the speaker and LED wires through the bottom of the mount base, mount wedge
(if applicable), mount gasket, mounting surface, and the mount plate that will be used to mount the KMFC.
The mounting hardware design provides versatility in vertical positioning to direct the speaker's output to
the ideal listening position, with the following confi gurations available. The mount base and mount wedge
may be rotated 180° from the diagrams shown below to aim the speakers at the opposite angle.
0 Degrees
IMPORTANT: You must apply a thin layer of the included anti-seize compound to ALL threaded fasteners
before installation to prevent galling, corrosion, seizing, and to improve gasket performance.
KMFC65
4
90
195
65
7, 17.8
9-11/16, 24.6
5 Degrees
KMFC8
4
92
300
150
8-3/16, 20.8
11-1/4, 28.5
10 Degrees
3