Operation - Bartscher 101923 Original-Gebrauchsanleitung

5.2 Operation

Before the first use

Before the first use, thoroughtly clean the device and accessories with warm water
and mild cleaning agent. Follow the instructions in point 6 "Cleaning and
maintenance ".

Thoroughly rinse the cleaned elements with clean water and then dry.

Assemble the device according to the instructions.
Attaching the mixing bowl shield

Fit the mixing bowl shield to the holder in the body
of the device. Place the mixing bowl shield above
the stirrer holder and fasten using the two included
fixing screws.
Attaching the mixing bowl
Before attaching the mixing bowl, switch off the device and place the fixing element of
the mixing bowl in the down position.
Fit the selected stirrer in the mixing bowl and
attach it to the holder.
There are three attaching points in the mixing bowl:
a) locking shaft (pin) at the rear of the mixing
bowl, to fit the relevant fastening notch in
the mixing bowl;
b) two pins at the left and right of the mixing
bowl support to catch the notches at the
mixing bowl handles.
Fixing screw
- 33 -