Gewiss Chorus GW 10 755 Handbuch Seite 33

In the Venetian blind mode, it is possible to manage the number of steps that are necessary for
the complete opening/closing of the slats.
The following procedure is used to store the number of steps:
1. Move the slats to the complete open condition.
2. Press the push-buttons related to channels 3 and 6 at the same time: the corresponding green
LEDs will flash at the same time.
3. Within 5 seconds (before the LEDs stop flashing) press the push-button relative to channel 1 for the
number of times corresponding to the number of slat adjustment steps (max. 10).
4. When the 5 second period has passed, the LEDs related to channels 3 and 6 will flash a number
of times that corresponds to the stored value.
If the bus voltage goes below 18V DC for more than 1.5 ms, the actuator no longer power the
outputs. When the Bus voltage is reset, the outputs will remain unpowered. If an alarm or forcing
was active when the bus voltage failed, when the bus voltage is reset the outputs will return to the
same condition they were in prior to the failure of the bus voltage.
The device does not require any maintenance. Use a dry cloth if cleaning is required.
IN SERVICE
Behaviour upon the failure
and resetting of the BUS supply
Maintenance
33
E
N
G
L
I
S
H