Gewiss Chorus GW 10 755 Handbuch Seite 25

INDICATOR LIGHT
Each channel of the push-button panel module has two signalling LEDs.
The default setting provides: night-time localisation (amber LED) and load status indication (green LED).
This default setting can be changed as follows.
Change mode input
• press channels 1 and 6 simultaneously for at least 3 seconds
• the LEDs activate according to the colour configuration that is active at that particular moment
• for each channel, cyclically change the colour of the LED corresponding to the status indication and night-
time localisation (colour and activation), by touching consecutively on the channel, as shown in the table.
LED CHANNELS 1..6
Flashing green
(0.5s ON, 0.5s OFF)
Flashing amber
(0.5s ON, 0.5s OFF)
Change mode output
• to save the new settings: touch channels 1 and 6 simultaneously for at least 3 seconds, or
• to exit without saving: wait 10 seconds.
Blinking and indications stop and any previous indications are restored.
GENERAL DESCRIPTION
Customisations
STATUS
SIGNALLING
Fixed green Green
Green
Amber
Fixed amber Amber
Flashing
None
green/amber
NIGHT-TIME
LOCALISATION
Amber
None
None
Green
None
25
E
N
G
L
I
S
H