Gewiss Chorus GW 10 755 Handbuch Seite 28

PROGRAMMING WITH THE EASY CONFIGURATOR
Program the push-button panel module with the Easy controller (GW 90 837 / GW 90 838 / GW 90
840).
If this device is added as an expansion to a KNX system programmed with the Standard
Unit (GW 90 831), please contact the Gewiss SAT Technical Assistance Service.
The device channels can be selected as you require:
• channels 1 -2 of the push-button panel: directly from the list of channels
• channels 3 -6 of the push-button panel: pressing the relevant push-button for each
channel, or directly from the list of channels
• actuator channels: pressing the programming key for at least 2 seconds, directly from
the list of channels or via channels 1 or 2 of the push-button panel when the latter
are not associated with other functions.
The functions can be created once the devices have been selected.
28