Designated Use; Technical Data - Abicor Binzel ABICUT 25K Betriebsanleitung

ABICUT 25K/45/75

1 Designated Use

1.1 Technical Data

Plasma cutting /gouging
Transport and storage
Relative humidity
Tab. 1
Ambient temperature
Application process
Type of use
Pilot current
Rated current and
corresponding duty cycle
Type of gas
Gas flow rate
Operating pressure
Min. / max. operating pressure
Air flow rate measured with
nozzle bore
Plasma air
Soft start
Gas post flow delay
Type of voltage
Protection type of the machine-
side connections
Type of ignition
Compressed air as plasma and
cooling gas
Tab. 2 Technical Data
ABICUT manual cutting torches are used for safe plasma cutting or gouging
of low- and high-alloy materials. They consist of the torch neck with equipment
parts and wearing parts, handle and cable assembly with central connector.
They conform to EN 60 974-7 and are not considered devices having their own
functions. Plasma cutting/gouging can only be carried out in connection with
a welding power supply.
ABICUT 25K
10 - 15 A (max. 18 A)
20 A / 35 %
approx. 29 l/min approx. 119 l/min
2 bar
1,8 / 3,0
0.65 mm
8.5 l/min
-
Contact
Yes
- 10 °C to + 40 °C
- 25 °C to + 55 °C
up to 90 % at 20 °C
ABICUT 45
Plasma cutting, plasma gouging
manual
40 A / 60 %
Compressed air
5 bar
4,5 / 6,0
0.8 mm
15.5 l/min
-
≥ 60 sec.
DC direct voltage
IP3X (EN 60 529)
Contact
Yes
1 Designated Use
ABICUT 75
15 - 22 A (max. 25 A)
75 A / 60 %
approx. 135 l/min
5 - 5.5 bar
4,5 / 6,5
1.2 mm
25 l/min
≥12 l/min
Contact / HF
Yes
EN - 3