Designated Use; Technical Data - Abicor Binzel ABIPLAS CUT Betriebsanleitung

2 Product Description
2 Product Description

2.1 Designated use

2.2 Use contrary to the designated use

2.3 Technical Data

Cutting
Transport and storage
Relative humidity
Ambient conditions
Tab. 2
®
Type ABIPLAS CUT
Type of use
Type of voltage
Operating mode
Voltage rating
Protection type of the machine-side
connections
Type of cooling
Minimum/Maximum value for gas
pressure
Electrical control device rating
General torch data (EN 60 974-7)
Tab. 3
EN - 4
These plasma-cutting torches ABIPLAS
The manual and machine cutting torches from this series are intended
exclusively for plasma cutting and gouging with compressed air as the plasma
gas. Designated use also includes the observance of the prescribed operating,
maintenance and servicing instructions.
Any use other than that described under "Designated Use" is considered
contrary to the designated use. Unauthorised conversions or power increase
modifications are not allowed.
- 10 °C to + 40 °C
- 25 °C to + 55 °C
up to 90 % at 20 °C
NOTE
P<4.8 bar will result in thermal overload of the torch!
®
CUT are air-cooled cutting torches.
70/110/150 MT 70/MT 110/ MT 150
manual automatic
DC direct voltage
Single gas torch
Peak value of 500V
IP3X
air-cooled
min. 4.8 bar/max. 7.0 bar
42 V / 0.1-1.0A
®
ABIPLAS CUT
IP2X