Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3 Putting into operation
3.1 Equipping the torch body
25K
ABICUT
45
ABICUT
75
ABICUT
75 HF
ABICUT
Execution
1
Distance spring
2
Complete protective cap
3
Compression spring
Fig. 1
Equip the torch body with standard wear parts
3.2 Connecting the plasma cutting torch
EN - 6
NOTE
• The cutting torch may only be put into operation by trained personnel.
NOTE
• Selection of plasma nozzle see
Tab. 3 on page EN-4
• Order data and part numbers for the equipment parts, wear parts and
accessories can be found in the current plasma product catalog of
ABICOR BINZEL.
• Use only original ABICOR BINZEL wear parts.
Equip the torch necks according to the following figure. Observe the correct
assignment and tight fit of the wear parts:
1
2
3
4
4
Nozzle
5
Swirl ring
6
Electrode
NOTE
• Observe the correct assignment and tight fit of the connections.
• Since the plasma nozzle cannot be protected against direct contact for
technical reasons, it is necessary for the plasma cutting power source to
satisfy the requirements of EN 60974-7, Item 7.4.2.
• The plasma cutting torch in connection with the plasma power source
must conform to EN 60974-10.
• Plasma power source must also be conform to EN 60974-1.
5
6
7
8
7
8
ABICUT 25K/45/75
9
10
Cooling tube
Torch neck
Werbung
Inhaltsverzeichnis
