Werbung
2.9 ASRock Smart Remote Installation Guide
ASRock Smart Remote is only used for ASRock motherboards with a CIR header.
Please refer to the procedures below for the quick installation and usage of ASRock
Smart Remote.
Step1.
Step2.
Step3.
Step4.
Step5.
26
Downloaded from
www.Manualslib.com
Find the CIR header located next
to the USB 2.0 header on your
ASRock motherboard.
Connect the front USB cable to the
USB 2.0 header (as below, pin 1-5)
and the CIR header. Please make
sure the wire assignments and the
pin assignments are matched
correctly.
Install the Multi-Angle CIR Receiver to the front USB port.
Boot up your system. Press <F2> or <Del> to enter the BIOS Setup Utility.
Make sure the option "CIR Controller" is set to [Enabled].
(Advanced -> Super IO Configuration -> CIR Controller -> [Enabled])
If you cannot find this option, please shut down your system and install
the Multi-Angle CIR Receiver to the other front USB port then try again.
Enter Windows. Execute ASRock's support CD and install the CIR Driver.
(It is listed at the bottom of driver list.)
ASRock Q77M vPro Motherboard
manuals search engine
USB 2.0 header (9-pin, black)
CIR header (4-pin, gray)
USB_PWR
P-
P+
GND
DUMMY
GND
IRTX
IRRX
ATX+5VSB
Werbung
Kapitel
