Werbung
Surround Display Feature
This motherboard supports surround display upgrade. With the internal VGA output
support (DVI-D, D-Sub and DisplayPort) and external add-on PCI Express VGA
cards, you can easily enjoy the benefits of surround display.
Please refer to the following steps to set up a surround display environment:
1. Install the PCI Express VGA cards on PCIE1 and PCIE2 slots. Please
2. Connect a DVI-D monitor cable to the DVI-D port on the I/O panel, connect a
3. Boot your system. Press <F2> or <Del> to enter UEFI setup. Enter "Share
4. Install the onboard VGA driver and the add-on PCI Express VGA card driver to
5. Set up a multi-monitor display.
24
Downloaded from
www.Manualslib.com
refer to page 18 for proper expansion card installation procedures.
D-Sub monitor cable to the D-Sub port on the I/O panel, or connect an
DisplayPort monitor cable to the DisplayPort port on the I/O panel. Then connect
other monitor cables to the corresponding connectors of the add-on PCI Express
VGA cards on PCIE1 and PCIE2 slots.
Memory" option to adjust the memory capability to [32MB], [64MB], [128MB],
[256MB] or [512MB] to enable the function of D-sub. Please make sure that the
value you select is less than the total capability of the system memory. If you do
not adjust the UEFI setup, the default value of "Share Memory", [Auto], will
disable D-Sub function when an add-on VGA card is inserted to this motherboard.
your system. If you have installed the drivers already, there is no need to install
them again.
®
For Windows
XP / XP 64-bit OS:
Right click on desktop, choose "Properties", and select the "Settings" tab
so that you can adjust the parameters of the multi-monitors according to
the steps below.
A. Click the "Identify" button to display a large number on each monitor.
B. Right-click the display icon in the Display Properties dialog that you
wish to be your primary monitor, and then select "Primary". When
you use multiple monitors with your card, one monitor will always be
Primary, and all additional monitors will be designated as Secondary.
C. Select the display icon identified by the number 2.
D. Click "Extend my Windows desktop onto this monitor".
E. Right-click the display icon and select "Attached", if necessary.
F. Set the appropriate "Screen Resolution" and "Color Quality" for the
second monitor. Click "Apply" or "OK" to apply these new values.
G. Repeat steps C through F for the display icon identified by the
numbers three to six.
ASRock Q77M vPro Motherboard
manuals search engine
Werbung
Kapitel
