Operating the cleaner
INSTALLING THE ROBOTIC VACUUM CLEANER
INSTALLATION ORDER
1. Turning the Power Switch on or off
2. Installing the Charger
3. Charging the Battery
TURNING THE POWER SWITCH ON OR OFF
To use the robotic vacuum cleaner, you must turn the
Power Switch on.
If you turn the Power Switch off, all settings will be reset.
1. Turn over the main unit and turn the Power Switch
- If the icons are not turned on, it indicates that the battery
- Note that turning the Power Switch off will reset all
- When no key is pressed for approximately 10 minutes
CAUTION
Downloaded from
www.Manualslib.com
To use the robotic vacuum cleaner, you must turn on the Power Switch at the
bottom of the main unit.
To charge the robotic vacuum cleaner, you must fi rst install
the charger.
Since the battery is discharged when the product is
purchased, you must fully charge the battery before use.
You should charge the battery completely before using the
robotic vacuum cleaner.
on.
charge is depleted. In this case, dock the robotic vacuum
cleaner to the charger station after turning the Power
Switch on.
settings.
when the power is on, the power is automatically turned off to save battery power. In
this case, to use this robotic vacuum cleaner again, please push the "Power" button
or "Start/Stop" button.
If the Power Switch is turned off, the robotic vacuum cleaner will not be charged
even if it is docked with the charger station.
manuals search engine
Operating the cleaner _19