Safety Warnings; Setting The Mode Of Operation - Märklin 55 Serie Handbuch

2
Operation
2.1 Function
• Suitable Operating System:
– DC power (max +/– 18 volts DC)
– AC power (32 VA Transformer)
– Märklin Delta
(only the 6607 Delta Station)
– Märklin Digital
(only the Control Unit)
– Märklin Systems
• Built-in locomotive decoder with
4 controllable auxiliary functions.
Also a function decoder with
2 additional auxiliary functions.
Address set the factory for the
locomotive decoder: 55.
Address set at the factory for the
function decoder: 54.
• 80 different addresses can be set.
• Adjustable maximum speed.
• Adjustable acceleration / braking
delay.
10
• Direction-dependent headlights.
• Built-in sound effects circuit, can
only be used in multi-train operation,
can be turned out manually.
• Built-in smoke generator.
• Minimum radius for operation:
1,020 mm / 40-5/32".
• Suitable track material: Märklin 1
Gauge track assortment.
No warranty or damage claims shall be accepted
in those cases where parts neither manufactured
nor approved by Märklin have been installed in
Märklin products or where Märklin products have
been converted in such a way that the non-Märklin
parts or the conversion were causal to the defects
and / or damage arising. The burden of presenting
evidence and the burden of proof thereof, that the
installation of non-Märklin parts or the conversion
in or of Märklin products was not causal to the
defects and / or damage arising, is borne by the
person and / or company responsible for the in-
stallation and / or conversion, or by the customer.

Safety Warnings

• This locomotive is to be used only
with an operating system designed
for it (Märklin 6646/6647 AC trans-
former, Märklin Delta, Märklin Digital
or Märklin Systems).
• This locomotive must never be
supplied with power from more
than one transformer.
• Pay close attention to the safety
warnings in the instructions for
your operating system.
2.2 Setting
the Mode
of Operation
DC = Direct current mode
of operation
AC = Alternating current mode
of operation
All other modes of operation are
automatically recognized.
2.3 Setting Maximum Speed,
Acceleration / Braking Delay
P1: Acceleration / braking delay
P2: Maximum speed