Axis Communications 225FD Installationsanleitung Seite 12

Page 12
Setting the IP address with ARP/Ping
1. Acquire an IP address on the same network segment your computer is connected to.
2. Locate the serial number (S/N) on the AXIS 225FD product label.
3. Open a Command Prompt on your computer and enter the following commands
(as appropriate for your operating system):
4. Check that the network cable is connected to the camera. Start/restart the camera by
disconnecting and reconnecting power.
5. Close the Command prompt when you see 'Reply from 192.168.0.125: ...' or similar.
6. Start your browser, type in http://<IP address> in the Location/Address field and press
Enter on your keyboard.
7. See page 13 for instructions on how to set the password.
Notes:
• The ARP/Ping command must be issued within 2 minutes of connecting power to the
• To open a command prompt in Windows: from the Start menu, select Run... and type cmd
• To use the ARP command on a Mac OS X, use the Terminal utility, which is found under
Downloaded from www.Manualslib.com
Windows syntax:
arp -s <IP Address> <Serial Number>
ping -l 408 -t <IP Address>
Windows example:
arp -s 192.168.0.125 00-40-8c-18-10-00
ping -l 408 -t 192.168.0.125
UNIX/Linux/Mac syntax:
arp -s <IP Address> <Serial Number> temp
ping -s 408 <IP Address>
UNIX/Linux/Mac example:
arp -s 192.168.0.125 00:40:8c:18:10:00 temp
ping -s 408 192.168.0.125
camera.
(or command in Windows 98/ME). Click OK.
Application > Utilities.
manuals search engine
AXIS 225FD Installation Guide