Resetting To The Factory Default Settings; Further Information - Axis Communications 216FD Installationsanleitung

Page 14

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the Control button pressed until the Power indicator flashes amber (this may take
up to 15 seconds).
4. Release the Control button. When the Power indicator displays green (which can take up
to 1 minute) the process is complete and the camera has been reset.
5. Re-install the AXIS 216FD using one of the methods described in this document.
It is also possible to reset parameters to the original factory default settings via the web
interface. For more information, please see the online help or the user's manual.
Accessing the AXIS 216FD from the Internet
Once installed, your AXIS 216FD is accessible on your local network (LAN). To access the
camera from the Internet, network routers must be configured to allow incoming traffic,
which is usually done on a specific port. Please refer to the documentation for your router
for further instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup

Further information

The user's manual is available from the Axis Web site at www.axis.com or from the Axis
Network Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your
AXIS 216FD. To see the currently installed firmware version, see the Basic
Configuration web page in the product's setup tools.
Downloaded from www.Manualslib.com manuals search engine
AXIS 216FD Installation Guide