Initial Set-Up - TechniSat DIGITRADIO 451 CD IR Bedienungsanleitung

5 Initial set-up

When you switch on the DIGITRADIO 451 CD IR for the first time, the initial set-up wizard is launched.
All settings can subsequently be changed at any time.
When carrying out the initial setup, follow the radio operating method for selecting and setting in menus as described in
Section 4.4.6.
> Select using your preferred operating language and confirm your selection.
> Pay attention to the data protection information in the radio display and confirm that you have read it.
> To start the initial setup wizard, select the [YES] field and confirm.
> In the next step you can select the time format. Select the setting you prefer ([12] or [24]) and confirm.
> You must then select the source (DAB+, FM or Internet) via which the DIGITRADIO 451 CD IR obtains and updates the
time and date.
If you have selected [Update from NET], the next step is to select the time zone so that the time is displayed correctly,
and whether daylight saving time or standard time applies at the time of setting.
The radio then searches for available wireless networks.
> Select the WLAN network you recognise and then select the preferred connection method.
[Press button]
[PIN]
[Skip WPS]
After selecting [Skip WPS], you can enter the password using the on-screen keyboard. Then select the [OK] field. If the
password entered is correct, a connection to the network is now established. The signal bars
display indicate whether a connection exists.
> After the network configuration has been completed, confirm the note that the initial setup is completed.
Start WPS function (please refer to the procedure for your router)
Start WPS function with a PIN (please refer to the procedure for your router)
Enter the network key manually (you only need to enter it once)
in the status bar of the
79
DE
EN
FR
NL