Troubleshooting - Beem Cyclo-Eccopower M8.001 Bedienungsanleitung

EN
The following table helps in localising and remedying minor faults:
Fault
The appliance does not
work after pressing the on /
off switch.
The automatic circuit
breaker in the electrical
distribution board trips.
The appliance is switched
off suddenly.
The cleaning power is
inadequate.
NOTE
► If you cannot resolve the problem with the steps described above, please contact
after-sales service.
BEEM - Elements of Lifestyle

Troubleshooting

Possible cause
Plug not inserted into socket.
Automatic circuit breaker in
electrical distribution board
tripped.
The internal safety switch has
switched off the appliance due
to overheating.
Too many appliances connect-
ed to the same power circuit.
Appliance is defective.
Plug has slipped out of the
socket.
The internal safety switch has
switched off the appliance due
to overheating.
Blockage of the vacuum hose,
of the telescopic tube or of the
brush.
Dust container is too full.
Dust container is not placed
correctly.
Filter is clogged.
Cyclo-Eccopower
Remedy
Insert plug.
Switch on the automatic
circuit breaker again.
Allow the appliance to
cool off. If and when
required, replace any
clogged filters.
Reduce the number of
appliances on the power
circuit.
Contact After-sales
Service.
Push the plug back into
the socket.
Allow the appliance to
cool off. If and when
required, replace any
clogged filters.
Remove the blockage.
Empty the dust con-
tainer.
Place dust container
correctly.
Clean the filter.
25