Empty The Dust Container; Cleaning And Maintenance; Clean The Appliance - Beem Cyclo-Eccopower M8.001 Bedienungsanleitung

EN

Empty the dust container

Please proceed as follows for emptying
the dust container (23):
Press the release button (15) and lift
‹
the dust container (23) off the base
appliance (see Fig. B1).
Hold the dust container (23) over a
‹
rubbish bin and press the emptying
button (14) on the handle (see Fig.
B2).
The bottom flap of the container
‹
opens automatically for emptying (see
Fig. B3).
Close the bottom flap again until it
‹
snaps into place.
Place the dust container (23) on the
‹
base appliance (7) in such a way that
it snaps into place.
Check the correct fit of the dust con-
‹
tainer (23).

Cleaning and maintenance

Before starting with the work, please read
the safety instructions in chapter Safety.

Clean the appliance

Use a slightly moist cloth to wipe off
‹
the outside of the appliance housing
and the accessory parts.
Clean the cyclone unit
Check the cyclone unit (22) every time
you empty the dust container, at the latest,
however, every three to six months. If you
find some dirt, clean the cyclone unit as
follows:
Press the release button (15) and lift
‹
the dust container (23) off the base
appliance (7) (see Fig. B1).
BEEM - Elements of Lifestyle
Cyclo-Eccopower
Release the cyclone unit (22) by turn-
‹
ing anti-clockwise (see Fig. C1).
Pull the cyclone unit (22) out of the
‹
dust container (23) (see Fig. C2).
Turn the holding ring anti-clockwise
‹
and remove the ring in order to be
able to remove the screen insert of
the cyclone unit (22) (see Fig. C3).
Remove the screen insert (see Fig.
‹
C4).
Use a dry cloth to clean all parts in-
‹
cluding the dust container or, if and
when required, apply a soft brush (see
Fig. C5).
In order to re-assemble the cyclone
‹
unit (22), push the screen insert on to
the cyclone unit again.
Push the holding ring on to the as-
‹
sembly and turn the ring clockwise
until it locks into place.
Place the cyclone unit (22) into the
‹
dust container (23) in such a way that
the marking arrows on the container
and the cyclone unit are in antiposition
(see Fig. D1).
Lock the cyclone unit (22) by turning
‹
the unit clockwise until it locks into
place (see Fig. D2).
Place the dust container (23) on the
‹
base appliance (7) in such a way that
it snaps into place.
Check the correct fit of the dust con-
‹
tainer (23).
NOTE
► If the dust container has not been
closed correctly, it cannot be placed
in the appliance.
23