Vacuum Cleaning; Park Position - Beem Cyclo-Eccopower M8.001 Bedienungsanleitung

Cyclo-Eccopower
If you want to use the combination noz-
‹
zle (25) as an upholstery nozzle, pull off
the brush attachment (see Fig. A8).
Removing
The combination nozzle (25) can be
‹
removed again by twisting and pulling
slightly.
NOTE
► Return the combined nozzle (25) to
the handle (5) after use.

Vacuum cleaning

Switching on the appliance
Pull the mains cable (17) out of the
‹
appliance at the plug, and insert the
plug into the socket.
Use the on/off switch (12) on the
‹
appliance to switch it on by means of
a short, slight push.
NOTE
► In case of longer operation, pull the
whole length of the connecting cable
out of the appliance (up to the yellow
mark maximum) in order to prevent
overheating. The red mark indicates
the end of wind.
► By means of the admixed air control-
ler (4), the suction capacity can be
reduced quickly in order to release
objects again that have been drawn
in.
Switching off the appliance
Use the on/off switch (12) on the
‹
appliance to switch it off by means of
a short, slight push.
22
Winding up the connection cable
After having switched off the
‹
appliance, pull the connecting cable
out of the socket by using the power
plug (17).
Push the cable winder button (16) to
‹
wind the connecting cable into the
appliance.
NOTE
► Pass the connecting cable through
your hand to ensure a correct wind
of the cable and to prevent an un-
controlled stop of the mains plug.

Park position

After cleaning, the telescopic tube can
be suspended with the hook in the hold-
ing appliance on the vacuum cleaner for
transport and space-saving storage.
Push the telescopic tube (3) in com-
‹
pletely - please also refer to the
chapter "Setting the telescopic tube
length"
Push the hook (9) of the floor brush
‹
(1) into the holder (11) on the appli-
ance.
Removing blocks
Proceed as follows for removing a
blockage:
Remove the vacuum hose (6) by
‹
pressing the top button on the con-
necting piece and pulling out the
vacuum hose (6) at the same time
(see Fig. A1).
Check the vaccum opening, the vac-
‹
uum hose (6) and the telescopic tube
(3) for blockages.
Remove all blockages and connect
‹
the vacuum hose (6) again.
BEEM - Elements of Lifestyle
EN