Troubleshooting - Beem Cyclone Mega-Clean Bedienungsanleitung

EN
The following table will help you locate and eliminate minor faults:
fault
The charging control indi-
cator of the hand vacuum
cleaner does not light
up after it is put onto the
charging station.
The automatic circuit
breaker in the electrical
distribution board trips.
The appliance does not
function after pressing the
ON/OFF switch.
Vacuum performance is
inadequate.
NOTE
► If you cannot resolve the problem with the steps described above, please contact
customer service.
BEEM - Elements of Lifestyle

Troubleshooting

Possible cause
Charging station power
adapter not plugged in.
Automatic circuit breaker in
electrical distribution board
tripped.
Rechargeable battery is fully
charged.
Hand vacuum cleaner was not
put into the charging station
correctly.
Too many appliances connect-
ed to the same power circuit.
No fault detected.
Battery not charged
Battery not charged
Dust container full up
Dust container not correctly
inserted.
Clogged filter element.
Cyclone Mega-Clean
Remedy
Insert plug.
Switch on the automatic
circuit breaker again.
Hand vacuum cleaner is
ready for operation.
Put the hand vacuum
cleaner correctly into the
charging station.
Reduce the number of
appliances on the power
circuit.
Contact customer
service.
Charge the battery.
Charge the battery.
Empty dust container.
Insert dust container
correctly
Clean the filter element.
25