Troubleshooting - Beem i-Turbo Bedienungsanleitung

EN
The following table will help you locate and eliminate minor faults:
Fault
The appliance does not
function after pressing the
ON/OFF button.
The automatic circuit
breaker in the electrical
distribution board trips.
NOTE
► If you cannot resolve the problem with the steps described above, please contact
customer service.
BEEM - Elements of Lifestyle

Troubleshooting

Possible cause
Charging station power supply
unit not plugged in.
Automatic circuit breaker in
electrical distribution board
tripped.
The internal safety switch has
switched off the appliance as
a result of overheating.
Appliance not charged.
Charging cable of the power
supply unit not connected.
Too many appliances connect-
ed to the same power circuit.
No fault detected.
i-Turbo Akkusauger 2 in 1
Remedy
Plug in the power supply
unit.
Switch on the automatic
circuit breaker again.
Allow the appliance to
cool down.
Charge the appliance.
Connect the charging
cable.
Reduce the number of
appliances on the power
circuit.
Contact customer
service.
29