SEB NUTRICOOK P4221437 Bedienungsanleitung Seite 59

IFU Nutricook SEB TEFAL_9L 4135696:4135696
To clean the control module and the valves
• Remove the control module from the lid and remove
the timer: see the "Control module" heading.
• Remove the timer.
• Wash the module under a gentle flow of running water.
• Visually check that the steam release outlet (A) is not
blocked by seeing light through it as shown in Fig.16.
If it is blocked, clean it under running water. Refit the
control module.
• Check that the operating valve (L) located inside the
lid is mobile, by moving the program selector to
and pressing with a finger: Fig. 17. You can only
do this when the module is fitted on the lid!
• You can clean this valve under running tap water.
• Also check that the safety valve (M) works properly by
using a cotton bud (for example) to press down hard
on the centre of the pipe, a part that should move: see
Fig. 18. You can clean this valve under running tap
water.
• You can also wash the control module in the
dishwasher, after taking care to remove the timer.
• Check that the steam release outlet seal (K) is in place.
If this seal is missing or has been damaged, leaks may
appear under the module when your NutriCook is in
use. The shape of the seal lets you easily remove and
refit it. If necessary, you can get replacement seals
from a SEB/Tefal Approved Service Centre.
• Check that the pressure indicator (D) is clean. It can be
cleaned under running tap water.
Never place the timer
in the dishwasher.
To store your NutriCook
• Turn the lid over and place it on the NutriCook body.
Safety
• Your NutriCook is provided with a number of safety
mechanisms.
Lid closure safety
• The jaws should be in contact with the lid edge. If this
is not the case, then steam will leak from around. The
pressure indicator and NutriCook will never come up to
pressure.
• Use a clean dry cloth.
• Never use solvents.
• Never place the timer under water.
4/01/10 14:58
Never dismantle the
control module.
Don't forget to remove
the timer before
cleaning the control
module by hand or in
the dishwasher.
Never use a cutting or
pointed object to clean
the safetly valve (M).
To clean the timer
Page 65
EN
60