SEB NUTRICOOK P4221437 Bedienungsanleitung Seite 54

IFU Nutricook SEB TEFAL_9L 4135696:4135696
Fitting and removing the timer
• To fit the timer (C) Fig. 7, first insert the rear part, then
clip down the front part.
• To remove the timer (C), press the tab and lift it.
EN
Cooking always takes place in two phases:
• The duration of the first pressure phase is directly
linked to the chosen recipe or the kind of ingredients
to be cooked, and this is the time you need to
programme on the timer using the – and + buttons.
• The second soft cooking phase is pre-programmed into
the timer and follows on automatically. All you have to
do is follow the guide below...
• You can switch the timer off at any time by pressing
simultaneously on both buttons.
• During cooking you can change the cooking time only
if the timer is positionned on the NutriCook. During the
soft steam phase, you cannot modify the cooking time.
I put the
ingredients
3
I programme
the cooking time
NutriCook heats up
55
• To make it easier to use your NutriCook, the timer is
there to help and guide you through your recipes.
2
1
I close
NutriCook ®
4
0
I turn on the heat,
to full power
0
I turn down the heat so
there is a constant,
steady release of steam.
4/01/10
Never open your
NutriCook before the
end of the soft cooking
phase, as you could
stop the cooking
process before the
ingredients are fully
cooked. Refer to the
"End of cooking"
heading.
Heat source
at max.
I select a
programme
MAXI
Programmed
time set
Heat source
at reduced
MAXI
Cooking
time
counts down
14:58 Page 60
Rear part
Front part
Tab