Diamond Blades - Agp R13 Betriebsanleitung

INTRODUCTION
This machine is equipped with two handles and a blade guard. It has an integrated water feed system as
required for diamond cutting. It is equipped with a portable residual current device (PRCD) aka GFCI for
electrical safety as well as overload and thermal protection. It must only be used with a diamond blade. It is
intended for cutting masonry, stone, concrete, reinforced concrete and similar materials. All other uses are
prohibited.
LIST OF CONTENTS
• Ring Saw
• Water Coupling Hose
• Face Spanner Wrench
• T-Handle Box Wrench
ASSEMBLY
• Mount the blade. ( See below "Mounting the Blade")

DIAMOND BLADES

ALLOWED TYPES OF BLADES
This machine may only use diamond ring saw blades.
• Only use either segmented or continuous rim diamond blades.
• If the diamond blades are segmented, the maximum allowable peripheral gap between segments is
10mm and must be with a negative rake angle.
• Only diamond ring saw blades of 13" (330mm) diameter of the 3 groove style may be used.
BLADE STORAGE AND TRANSPORT
Store the machine and blade in such a way that it is protected from being bent or damaged when the machine
is not in use.
A damaged blade can cause irregular conditions, which can cause imbalance and result in a hazard.
Always inspect new blades for storage or transport damage.
ABOUT DIAMOND BLADES
Diamond blades consist of a steel core with diamond segments added to its periphery.
GB
8