Water Connection - Agp R13 Betriebsanleitung

test for slipping, use the T-handle wrench on the nut of the guide wheel and turn it back and forth. When
the thrust tension is just enough so that the blade follows the quide wheel movement, tighten a further
1/8 turn. Do not over tension the guide tensioner. Overtensioning will unnecessarily increase the
load on the motor and increase wear on the mechanism. Repeat for the other guide tensioner.
7.
Use the T-handle wrench on the arbor bolt and rotate it back and forth while tightening the drive
tensioner knob until there is just enough tension so that the drive wheel is turning the blade without
skidding. Then tighten a further 1/4 turn. Do not over tension.
8. Slide the drive wheel cover plate into position over the drive wheel and tighten the thumb knob.
9.
The drive tension will need to be periodically adjusted because, over time, the drive wheel and blade
interface will wear. When this happens, tighten the drive tensioner slightly, just enough to keep the blade
from slipping.
WARNING: Never adjust the drive tension while the saw is running.
NOTE: Always replace the drive wheel with a new one when replacing a worn blade. The drive wheel and
blade wear together and should be replaced as a set.
Inspect the blade before use. It must not be cracked, warped or damaged in any way that would cause a hazard
in operation. Loose diamond segments can be ejected at high speed, causing possible injury. Always check
that the diamond segments are not under cut. If the diamond segments are thinner or nearly thinner than the
blade core, the kerf will be too tight fitting and could easily lead to kickback.
Inspect the blades for segment damage, or any other damage which could cause hazardous operation.
SPLASH GUARDS
The spring-loaded splash guards are useful to help contain slurry which splashes toward the back. The upper
guard has an over-center spring which will lock into the fully open position if it is pulled all the way back. The
lower guard has a clip which can be used to lock the guard in the fully open position.

WATER CONNECTION

Water is a basic requirement for this tool. The water also serves as a coolant to avoid the working surface of
the diamond segments from overheating. Water also keeps down dust and flushes away abrasive particles.
WARNING: Check all connections of the water feed system to ensure there are no leaks. Inspect hoses
and other critical parts which could deteriorate.
WARNING: The maximum water pressure should not exceed 70 psi (4 bar).
Note: Use a wet vacuum to collect cooling water if nearby objects could be damaged by water.
GB
10