EINHELL HES 200 Bedienungsanleitung Seite 9

Anleitung HES 200 -12sprachig
Adjustment of the cutting angle
1. Release the 2 lock screws 1
2. Adjust the shoe to the desired angle between 0 and 45°.
3. Tighten the lock screws 1.
Adjustment of the splitter
1. Open the hinged guard hood and hold.
2. Release screws.
3. Adjust splitter and tighten again.
09.11.2001 7:13 Uhr
Important!
Pull out the plug before
making any changes to the
circular saw!
Changing the saw blade
1. Open the hinged guard hood and hold.
2. Apply socket wrench and release screw.
3. Hold up flange using the pin-type wrench.
4. Remove the flange and saw blade by dropping downwards.
5. Clean the flange and insert a new blade. Note the direction
5. of rotation (see arrow on the guard hood).
6. Tighten the hexagon-head bolt and check for concentricity.
7. Adjust splitter.
Switching on and off
To switch on: Press lock button 3 and the key simultaneously
To switch off: Release the lock button and the key
Seite 9
Switching on
Before pressing the On/Off
switch, check that the saw blade
is properly fitted, that the moving
parts run smoothly and that the
clamping screws are tight.
GB
9