Pairing The Wireless Remote Control; Pairing With The Dhe Connect / Dhe Touch Instantaneous Water Heater - STIEBEL ELTRON FFB 4 EU Bedienung Und Installation

INSTALLATIoN

Pairing the wireless remote control

4
1 Wireless module PCB
2 Locking tabs
3 Wireless module plug position
4 Appliance PCB plug position
f Mount the wireless module PCB in the retainer provided. f
Insert the wireless module PCB into the groove and pivot
downwards. The locking tab must audibly click into place.
f Attach the connecting cable (plugs as shown). f
f Pair the mini wireless remote control and any programming f
units installed with the wireless adaptor. For the pairing pro-
cess, use the description of the relevant instantaneous water
heater.
22 | FFB 4 EU | FFB 4 Set EU | FFB 4 AP | FFB 4 Set AP
2 3
1
9. Pairing the wireless remote control
9.1 Pairing with the DHE Connect / DHE Touch
instantaneous water heater
A new wireless remote control is paired as follows:
f Select the following menu items one after the other on the f
programming unit of the instantaneous water heater: "Set-
tings / Service / Wireless / Connect other wireless subscrib-
ers". A pop-up appears to indicate that the device is ready to
be paired; confirm this with OK.
f Press keys "1" and "2" simultaneously on the wireless re- f
mote control and hold for 3 seconds. Pairing takes place
automatically and is acknowledged when "L" is shown on the
display. The yellow LED flashes quickly several times in suc-
cession and then goes out.
Note
When pairing and unpairing the wireless remote control,
see also the operating instructions for your instantaneous
water heater.
See the next chapter for further pairing options.
www.stiebel-eltron.com