Package Contents; Specification; System Requirements; Driver Installation - i-tec USB-C 3.1 Gebrauchsanweisung

i-tec USB-C 3.1 Gigabit Ethernet Adapter
INTRODUCTION
i-tec USB-C 3.1 Gigabit Ethernet Adapter allows user's computer instantly
connect to a 10 / 100 / 1000Mbps network through an USB-C port. No need to
purchase an extra Gigabit network card and share a PCI / PCIe or Express /
CardBus slot. With compliance with USB 3.1 specification, this adapter
ensures true 10 / 100 / 1000Mbps network speed without any compromise.
Besides, compact and bus-powered design means external power is not
required.

PACKAGE CONTENTS

i-tec USB-C Gigabit Ethernet adapter with cable (15 cm)
Ÿ
Quick Start
Ÿ

SPECIFICATION

USB-C to 10 / 100 / 1000Mbps Gigabit Ethernet
Ÿ
1x RJ-45 for Ethernet cable connection
Ÿ
Supports Wake-on-LAN, Jumbo frame up to 9k bytes, detection of cable
Ÿ
crossover MDI / MDIX
Support IEEE 802.3az (Energy Efficient Ethernet)
Ÿ
Support IPv4/IPv6 pack Checksum Offload Engine (COE) to reduce
Ÿ
CPU loading
Chipset Realtek RTL8153
Ÿ
Power: USB Bus Power 5V
Ÿ
Supported OS: Windows® 7, Windows® 8, Windows® 8.1, Windows®
Ÿ
10, Mac® OS X, Linux, Android
Operation Temperature: 10-40°C
Ÿ
Storage Temperature: -10-80°C
Ÿ
Size: 66 x 20 x 15 mm
Ÿ
Weight: 19 g
Ÿ

SYSTEM REQUIREMENTS

Windows® 7 / 8 / 8.1 / 10; Mac® OS X; Linux; Android
Ÿ
Free USB-C
Ÿ

DRIVER INSTALLATION

Note: DO NOT connect the Ethernet adapter to your computer before
completing the installation of driver!
EN
07