AC Schnitzer 2511 10 410 Montageanleitung Seite 16

F itt in g In s truct ion s
AC Schnitzer Aluminium Gear Knob with Digital Gear Display
3. Teaching ( cont'd. )
If the vehicle does not have a sixth gear, obviously it cannot be
selected. When requested in the first phase to select the sixth
gear, the gear shift lever should remain in the previous position
and not moved. The system recognises the shift lever has not
moved and skips to the second phase. Once the programming
phase is completed, the system stores the gear positions and
subsequently starts to recognise the gear positions ( flashing
ceases ).
However, a programming teach phase can be initiated each
time the system is switched on by putting the gear shift lever in
first and fourth gears twice ( see Section ). The programming
procedure can be interrupted by switching off the power supply
by turning off the ignition. This can be helpful if errors are
made during the procedure.
Each time the ignition is switched on, the display flashes for
several seconds. If the first and fourth gears are not selected
within the given time ( as described ), the electronic display
changes to a normal mode the last programming assignment is
displayed.
Subject to errors and modifications!
AC Schnitzer - automobile Technik - Neuenhofstraße 160 - D - 52078 Aachen - Tel. 0241/5688 -130
Fitting Instructions No.: 2511 10 410 / Issue: 16.09.2008
8
Fax -135