AC Schnitzer 2511 10 410 Montageanleitung Seite 10

G en era l N ote s!
AC Schnitzer Aluminium Gear Knob with Digital Gear Display
Important Notes!
Read these Fitting Instructions carefully before starting installation work. AC Schnitzer bears no liability for damage
caused by incorrect installation!
These Fitting Instructions are intended for use by an authorised AC Schnitzer dealer.
These Fitting Instructions are directed in each case to specialists trained in BMW vehicles, with corresponding
professional knowledge.
All figures show LHD vehicles; for RHD vehicles proceed accordingly or following separate installation instructions.
No warranty is given for the correctness of the gear number.
Depending on the particular type of the vehicle and gear positions, brief cross fading in the display may occur at
extreme acceleration. This is due to the physical characteristics of the sensors and is not a product or
manufacturing defect.
After initial use, the position of the shifter knob must not be altered ( do not turn etc. ) because this can cause
malfunctions. If this should happen, the shifter knob must be reprogrammed.
Fitting
All work must be performed taking into account current safety requirements.
Fitting Time ( 1 unit = 5 minutes )
The fitting time is around 8 units, which may differ according to the condition and equipment level of the vehicle.
Tools Required
Soldering iron
Side cutter
Cutter
Suitable tools for release and attach covers
AC Schnitzer - automobile Technik - Neuenhofstraße 160 - D - 52078 Aachen - Tel. 0241/5688 -130
Fitting Instructions No.: 2511 10 410 / Issue: 16.09.2008
2
Fax -135