Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION FOR GROUP I
(weight 9-18kg)
WARNING:
•
The installation for group I is forward facing if your child weight is
between 9 and 18kg.
•
For group I there are three levels of backrest incline that can be
used – level 1/2/3
•
In case the child has a lot of room left in the seat keep using the
reduction cushion
IMPORTANT:
•
The 3-point harness safety belt is used only to lock the car seat
in place. The child should be secured by 5-point harness safety
belt which is in the car seat
5
Pull the red lever (see schematics fi g. 6) and adjust the backrest
to one of three possibilities (1/2/3). See side of the safety seat for
level numbers. Make sure that the backrest position is secure. Once
fi nished you can place the safety seat in the car.
6
Place the safety seat in forward position in the car and make sure that
it adjoins the car seat backrest
7
Pull out the 3-point safety belt and pass it through the safety seat as
shown on pic. 3. Hip part of the belt should be placed in group I guiding
slot – marked with red sticker see pic. 3-1. Next fold back the locking
device on the side of the seat (see schematics fi g. 16) and put the
shoulder part of the belt through the locking mechanism see pic. 3-2.
8
Lock the 3-point harness belt by connecting the belt anchor with the
buckle. Make sure that the belt is tight and the seat is secure. In order
to constringe the belt, it might be needed to pull next to the locking
mechanism and guide hooks. Once all elements are closed, and the
belt is constringed tug the seat to see if all elements work as intended.
34
Werbung
Inhaltsverzeichnis
