Suitable for installation only if type-approved vehicles are equipped with
three-point retractor seat belts that have been approved according to
UN / ECE Regulation No. 16 or other equivalent standards
WARNING
•
Read carefully the manual before installing the seat, incorrect
installation can be harmful
•
Plastic parts or any solid parts of the child restraint should be placed
and installed in such a way that, under normal conditions of use of
the vehicle will not become trapped by the seat adjustment system
or door of the vehicle
•
The seat should be installed perpendicular to the longitudinal axis
of the vehicle
•
Never leave your child unattended in the seat
•
The car seat should be installed in group 0+ only rearward facing,
in group I rearward or forward facing the direction of travel using
a 3-point belt, while the child will be fastened in the seatbelt (5-point
belts). In group II, the seatbelts should be pulled out and the child
fastened in car seat belts (3-point seat belts).
•
The seat may only be used to secure a child in the vehicle, it is not
intended for home use.
•
Do not use the seat if the seatbelts (5-point and 3-point) are not
fastened correctly or are twisted.
•
Make sure that all straps that fasten the safety seat to the vehicle are
tighten, that the straps that fasten the child, fi t the body structure and
that the straps are not twisted
•
It is important to ensure that all lap belts run low so that the pelvis
is fi rmly held.
•
The safety seat should be replaced if it was subjected to any type of
force caused by an accident
•
Stop using the seat if any of its parts are damaged or became loose
as a result of an accident
•
It is not recommended to use car seats for more than 5 years from
the date of production, as some product properties may change
(eg aging of plastic).
•
Any modifi cations made to the safety seat as well as the installation
of additional components without the authority's approval may pose
a risk.
26